Table of Contents
Advertisement
Crestron TPS-4500 & TPS-4500L
Operations Guide - DOC. 5891A
13. Use the #2 Phillips screwdriver and fully tighten all 12 pan head
screws. Use caution and do not crack or damage mounting surface.
14. Mate the four posts of the bezel with the holes drilled into the mounting
surface and firmly press on the bezel over the touchpanel.
Cover Touchpanel with Bezel
COVER
TOUCHPANEL
WITH BEZEL
NOTE:
WIRING NOT SHOWN
FOR CLARITY
DRYWALL
Touchpanel Removal (TPS-4500L)
If it is necessary to remove the TPS-4500L after it has been installed into a mounting
surface, complete the following steps in the order provided to remove the
touchpanel. The only tool required is a #2 Phillips tip screwdriver.
1. Lift the plastic cover off the touchpanel. Do not apply excessive
pressure to the touchscreen.
2. Loosen and remove the screws that secure touchpanel to the mounting
option in use.
3. Using equal pressure, carefully remove the touchpanel from the
opening.
4. If necessary, secure and label the attached cables before disconnecting
them from the back of the touchpanel.
Recommended Cleaning
Keep the surface of the touchscreen free of dirt, dust, or other materials that could
degrade optical properties. Long-term contact with abrasive materials can scratch the
surface, which may degrade image quality.
For best cleaning results, use a clean, damp, non-abrasive cloth with any
commercially available non-ammonia glass cleaner. The faceplate may not provide a
complete watertight seal. Therefore, apply cleaning solution to the cloth rather than
the surface of the touchscreen. Wipe touchscreen clean and avoid ingress of moisture
beneath panels.
12 Inch Tilt/Lectern Touchpanels: TPS-4500 & TPS-4500L • 21
12 Inch Tilt/Lectern Touchpanels
Advertisement
Table of Contents
