Table of Contents
Advertisement
Crestron Isys™ TPS-3000L
Programming Software
Have a comment about
Crestron software?
Direct software related suggestions
and/or complaints to Crestron via
email (software@crestron.com).
Do not forward any queries to this
address. Instead refer to "Further
Inquiries" on page 45 for assistance.
Operations Guide – DOC. 6077
6.4" Lectern/Wall Mounted Touchpanel
1. Lift the plastic cover off the touchpanel. Do not apply excessive
pressure to the touchscreen.
2. Remove the plastic buttons from the touchpanel. If the buttons are
engraved, be sure to record the button engraving with the button
location so that the buttons can be properly returned.
3. Loosen and remove the four screws that secure touchpanel to the
mounting option in use.
4. Using equal pressure, carefully remove the touchpanel from the
opening.
5. If necessary, secure and label the attached cables before disconnecting
them from the back of the touchpanel.
Recommended Cleaning
Keep the surface of the touchscreen free of dirt, dust, or other materials that could
degrade optical properties. Long-term contact with abrasive materials can scratch the
surface, which may detrimentally affect image quality.
For best cleaning results, use a clean, damp, non-abrasive cloth with any
commercially available non-ammonia glass cleaner. The faceplate may not provide a
complete watertight seal. Therefore, apply cleaning solution to the cloth rather than
the surface of the touchscreen. Wipe touchscreen clean and avoid ingress of moisture
beneath panels.
Setup is easy thanks to Crestron's Windows
Application Builder™ (AppBuilder) creates a complete project, with no special
programming required. Crestron AppBuilder completes all necessary programming
for a base system including all touchpanel screens and the control system program.
Once Crestron AppBuilder creates the project, the system interfaces and program
logic can be customized. It can easily be modified with Crestron development tools
(i.e., SIMPL™ Windows
The program output of Crestron AppBuilder is a SIMPL Windows program with
much of the functionality encapsulated in macros. Therefore, extending the
capabilities of the system is very easy. Crestron AppBuilder and SIMPL Windows
are intended for users with different levels of programming knowledge. Crestron
AppBuilder is easier to use for the beginning programmer, and much faster for all
programmers. However, it does not allow the degree of control and flexibility that
SIMPL Windows does. Of course, one can initiate programming using the easiest
method (Crestron AppBuilder) and use advanced techniques that are available from
SIMPL Windows to customize the job.
Crestron AppBuilder comes with templates for all supported interfaces. If a user
wishes to create a touchpanel project using templates with a different look-and-feel
this can be accomplished by making a custom template. This custom template can
then be used by Crestron AppBuilder to create the final project files to be loaded into
the panels. Alternatively, VT Pro-e can be used to tweak projects created with
Crestron AppBuilder or develop original touchpanel screen designs.
The following are recommended software version requirements for the PC:
•
Application Builder version 1.1.6 or later with Application Builder
Templates version 2.12 or later. Requires SIMPL Windows.
6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-3000L • 23
-based programming software. Crestron
and VisionTools™ Pro-e (VT Pro-e) software packages).
Advertisement
Table of Contents
