Crestron CT-1000 & LC-1000
Operations Guide – DOC. 5813B
Insert Series 1000 into Opening (Buttons Shown as Attached)
Custom engraved faceplate and/or keys can be ordered separately by using the
Crestron Engraver Software. Version 2.0.0.6 or later is available from the
Downloads | Software Updates section of the Crestron website (www.crestron.com).
There are even plastic faceplates that accept metal and non-metal inlays for that
custom contemporary appearance. Call a Crestron customer support representative
for the specific details.
NOTE: If it is necessary to remove the touchpanel, secure and label the attached
cables before disconnecting them from the back of the touchpanel.
Touchpanel Removal
If it is necessary to remove the touchpanel after it has been installed into a mounting
surface, complete the following steps in the order provided to remove the
touchpanel. The only tool required is a #1 Phillips tip screwdriver.
1. Lift the plastic faceplate off the touchpanel.
2. Remove the plastic buttons from the touchpanel. If the buttons are
engraved, be sure to record the button engraving with the button
location so that the buttons can be properly returned.
3. Loosen and remove the four screws that secure touchpanel to the
mounting option in use.
Series 1000 Wall-Mounted Touchpanels • 13
Touchpanels