Table of Contents
Advertisement
6.4" Lectern/Wall Mounted Touchpanel
SCREEN SETTINGS -
BRIGHTNESS
SCREEN SETTINGS – AUTO
BRIGHTNESS
THRESHOLD
SCREEN SETTINGS -
ORIENTATION
16 • 6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-3000L
BRIGHTNESS
Press the Brightness button to open the SCREEN SETTINGS – BRIGHTNESS
display. Manual controls are located on the left side and automatic controls are
located on the right side. Two buttons, ENABLE and DISABLE, are used to
determine whether the touchpanel brightness is controlled manually or automatically
via thresholds. Select the ENABLE button for automatic settings. Notice that a 'net'
covers the manual controls on the left. The DISABLE button removes the 'net' to
permit manual advancements (use the UP button) and reductions (use the DOWN
button) to the screen brightness.
Choose the SETUP button on the SCREEN SETTINGS – BRIGHTNESS display to
open the SCREEN SETTINGS – AUTO BRIGHTNESS THRESHOLD display,
shown to the left. A photosensor on the front panel permits this exclusive light-
sensing touchpanel to automatically determine if the amount of light sensed exceeds
a set threshold value. This threshold value allows the touchpanel to switch between
daytime super bright (high brightness) and evening soft glow (low brightness)
automatically. The right side of this display shows the CURRENT VALUE as
detected by the photosensor. This value, represented by xxx in the illustration, can
range from 0% (dark) to 100% (very bright). The THRESHOLD VALUE located on
the left side of the display needs to be set to automatically adjust brightness. The
numerical value, represented by xxx in the illustration, can range from 0% (dark) to
100% (very bright). Use the UP and DOWN buttons to increase and decrease the
THRESHOLD VALUE, respectively.
If the CURRENT VALUE has exceeded the THRESHOLD VALUE, the screen
switches to high brightness. When the CURRENT VALUE is less than the
THRESHOLD VALUE, the screen switches to low brightness.
ORIENTATION
There is no 'top' or 'bottom' when installing the TPS-3000L. Press the Orientation
button to open the SCREEN SETTINGS – ORIENTATION display, shown to the
left. This setup feature allows the orientation of the display to be rotated 180° with
the press of a button. This allows for optimum viewing whether installing the
touchpanel into a wall or a lectern. When installing the touchpanel into a wall, the
screen should be set to "Right Side Up" (pushbuttons on the left side). When
installing the touchpanel into a lectern, the screen orientation should be set to "Up
Side Down" (pushbuttons on the right side).
Two buttons, Up Side Down and Right Side Up, are used to set the orientation of
the screen. The selected button appears in red text. By definition, the Right Side Up
button displays the screen with connectors at the bottom of the touchpanel and as a
result, the term Orientation Upright appears on the SCREEN SETTINGS display's
center button. The Up Side Down button displays the screen with connectors at the
top of the touchpanel and the term Orientation Inverted appears on the SCREEN
SETTINGS display's center button. Use the Return button to get back to the
SCREEN SETTINGS display.
NOTE: Whether the touchpanel screen orientation is set to Upright or Inverted,
the sequence of digital join numbers remains the same (1 through 5 for both modes).
Refer to "Screen Orientation" on page 8 for more information about lectern or wall
installation.
Crestron Isys™ TPS-3000L
Operations Guide – DOC. 6077
Advertisement
Table of Contents
