Table of Contents
Advertisement
Wired Touchpanels
Configuring the Touchpanel
Main Menu
Calibration Menu
NOTE: When touching the screen
during calibration, be as accurate
as possible.
8 • Series 1600 Wired Touchpanels
Tiltcase Model - Mounting Details
To configure the unit, it may be necessary to access a series of setup screens prior to
viewing run-time screens that are loaded into the touchpanel for normal operation.
The Main Menu for configuring the touchpanel appears when a finger is held to the
touchscreen as power is applied. Remove your finger when the message "SETUP
MODE" appears on the touchscreen. Holding a finger to the touchscreen for five
seconds after the "SETUP MODE" message is displayed sets the brightness to high
and the contrast to a default level.
Upon entering SETUP MODE, the Main Menu, shown to the left, displays four
buttons: SAVE SETUP AND RUN PROGRAM, SETUP, DIAGNOSTICS, and
TOUCH SCREEN CALIBRATION.
The SAVE SETUP AND RUN PROGRAM button, located at the upper right
corner of the Main Menu, saves all of the setup information to EEPROM and
displays the main page that has been programmed into the system.
The remaining buttons on the Main Menu open additional menus and their
functionality is described in the following paragraphs.
Calibration Menu
Calibration of the touchscreen is required if the active touch area of a button does
not coincide with the button's image. Select the TOUCH SCREEN
CALIBRATION button to display the Calibration Menu, shown to the left. The
Calibration Menu offers the choice to initiate calibration with the Perform
Calibration button or return to the previous screen with the Return to Main Menu
button. Choose an option by touching the correct button. When touching the screen,
be as accurate as possible.
If you proceed to calibrate the touchpanel, the screen prompts you with the message
"Touch Screen Calibration Menu Touch Upper Left Corner" centered on the display.
A hand with a pointing finger indicates the correct corner. Touch the corner of the
screen to initiate calibration. Another message, "Touch Screen Calibration Menu
Touch Lower Right Corner", appears and a hand with a pointing finger indicates the
Crestron Series 1600
Operations & Installation Guide - DOC. 5836A
Advertisement
Table of Contents
