Communication Settings - Crestron Isys TPS-3000L Operation Manual

Crestron Isys™ TPS-3000L
Operations Guide – DOC. 6077
6.4" Lectern/Wall Mounted Touchpanel

Communication Settings

Connection of a PC to the TPS-3000L touchpanel can be direct via the RS-232 port
on the touchpanel or through a control system (Cresnet). Both methods of connection
provide setup for RS-232 communication.
To prepare the TPS-3000L for uploading or upgrading, refer to the following figure
for a typical connection diagram.
Typical Connection Diagram when Uploading a Project
Cresnet
Control System
To prepare the TPS-3000L for uploading or upgrading directly from a PC, refer to
the following figure. Connect the RS-232 port of the computer directly to the RS-232
port of the touchpanel. Refer to page 18 for RS-232 cable information.
Typical Connection Diagram when Uploading a Project Directly to the Touchpanel
RS-232
via Crestron Cable Number
STCP-502PC or equivalent
1. Start SIMPL Windows or VT Pro-e.
2. From the menu bar, select Tools | Viewport to open the Crestron
Viewport. (If communication settings are correct, the prompt should
be TPS for direct communications).
3. Refer to the following figure. From the Viewport menu, select Setup |
Communications settings (alternatively, depress Alt+D) to open the
"Port Settings" window.
6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-3000L • 37
RS-232