Identity Code; Configuring The Touchpanel - Crestron TPS-12 Operation Manual

®
Crestron Isys TPS-12G/15G-QM-L
QM Network Topology with TPS-12G/15G-L Acting as an Endpoint and a Transmitter
Origination Points
QM
QM-WMC
QM
QM-WMC
Operations Guide – DOC. 6356
Midpoints
QM
QM-MD7x2 QM-MD7x2

Identity Code

All equipment and user interfaces within the network require a unique identity code
(Net ID). These codes are two-digit hexadecimal numbers ranging from 03 to FE
(Net ID 02 is reserved for control processors). The Net ID of each unit must match
an ID code specified in the SIMPL Windows program. The Net ID is set using the
internal setup menu (refer to "Interface Menu" on page 20). The Net ID may also be
set using Crestron Toolbox (refer to "Establishing Communications" on page 44).

Configuring the Touchpanel

NOTE: The only connection required to configure the touchpanel is power (supplied
via Cresnet). Refer to "Hardware Hookup" on page 31 for details.
To configure the unit, it may be necessary to access a series of setup screens prior to
viewing run-time screens that are loaded into the touchpanel for normal operation.
The MAIN MENU for configuring the touchpanel appears when a finger is held to
the touchscreen as power is applied, or after the hardware reset button is pressed and
released. Remove your finger when the message "SETUP MODE" briefly appears on
the touchscreen.
Upon entering SETUP MODE, the MAIN MENU, as shown in the following
illustration, displays four buttons: Touch Screen Calibration, Exit and Run
Program, Setup, and Diagnostics.
The Exit and Run Program button verifies that all of the setup information has
been saved to the EEPROM and displays the main page that has been programmed
into your system. The remaining buttons on the MAIN MENU open other menus,
which are discussed in subsequent paragraphs.
Wall Mount Touchpanels
Endpoints
QM
TPS-12G/15G-L
This TPS-12G/15G-L
acts as both an
endpoint for signals
from the QM-WMC
origination points AND
a QM transmitter to
the QM-RMCRX.
Wall Mount Touchpanels: TPS-12G/15G-QM-L ¥ 17
QM
QM-RMCRX-BA
This QM-RMCRX-BA
does not violate the
two-midpoint rule as it
is receiving an RGB
signal from the TPS-
12G/15G-L transmitter.