Crestron TPS-12 Operation Manual page 25

®
Crestron Isys TPS-12G/15G-QM-L
Operations Guide – DOC. 6356
The Ethernet Enable and Disable buttons determine the status of the touchpanel's
Ethernet communications.
NOTE: TPS-12G/15G-L do not support a wireless Ethernet connection.
Select the Save and Return button located on the INTERFACE MENU to return to
the SETUP MENU.
Ethernet
Selection of the Ethernet button from the SETUP MENU displays details such as
the IP Address, Subnet Mask, Default Router, IP Table, etc. The settings can only be
viewed from this screen. The enable/disable Ethernet feature is provided on the
INTERFACE MENU. Ethernet settings are made through Crestron Toolbox. Refer
to page 48 for additional Ethernet setup details.
RS-232 Menu
The touchpanel allows for one of four RS-232 communication modes:
Console (i.e., loading projects and firmware)
•
Touch Output (communication of touch coordinates to an external device)
•
Mouse Input (allows a mouse to control the touchpanel)
•
External Touch Input (allows another device to control the touchpanel.
•
For convenience, the RS-232 MENU also permits the selection of the RS-232
communication options, RTS On/Off, XON-XOFF On/Off, Baud Rate, Data Bits,
Parity, and Stop Bits.
Touch the communication option to select communication parameters and then select
Save and Return to save the RS-232 settings and return to the SETUP MENU.
Default settings: Console mode, Baud rate: 115200, data bits: 8 bit, parity: none, stop
bit: 1, XON/XOFF off, RTS off.
RS-232 MENU
Wall Mount Touchpanels
Wall Mount Touchpanels: TPS-12G/15G-QM-L ¥ 21