Setup; Identity Code; Power - Crestron TPMC-4XG Operation Manual

Isys i/O™ Handheld WiFi Touchpanel

Setup

12 • Isys i/O™ Handheld WiFi Touchpanel: TPMC-4XG

Identity Code

The IP ID is set within the TPMC-4XG's table using Crestron Toolbox™ or during
configuration of the unit in the Setup pages of the TPMC-4XG. For information on
setting an IP table, refer to the Crestron Toolbox help file. The IP IDs of multiple
TPMC-4XG devices in the same system must be unique.
When setting the IP ID, consider the following:
•
The IP ID of each unit must match an IP ID specified in the SIMPL™
®
Windows program.
•
Each device using IP to communicate with a control system must have a
unique IP ID.

Power

The TPMC-4XG is powered via its internal battery. Connect the included power
supply to the TPMC-4XG-DS docking station.
NOTE: Before using the TPMC-4XG for the first time, charge its internal battery
for at least eight hours by placing it on the TPMC-4XG-DS docking station.
It takes the TPMC-4XG about eight hours to recharge while in use. A fully charged
battery can provide up to three hours of use at the full screen brightness setting.
The battery recharge capacity is 500 cycles to 80% of original capacity.
NOTE: When not using the TPMC-4XG, store the unit on its docking station.
Crestron TPMC-4XG
Operations Guide – DOC. 6655B