Crestron TPS-12 Operation Manual page 54

Wall Mount Touchpanels
50 ¥ Wall Mount Touchpanels: TPS-12G/15G-QM-L
pinouts for straight through and crossover RJ-45 cables. Pins 4, 5, 7, and 8
are not used.
RJ-45 Straight Through Cable – For Connection Through Hub
FROM COLOR
PIN
1 White/Orange
2 Orange
3 White/Green
6 Green
RJ-45 Crossover Cable – For Direct PC Connection
FROM COLOR
PIN
1 White/Orange
2 Orange
3 White/Green
6 Green
5. Once the cable connections are made, open Crestron Toolbox and click
Tools | Manage Address book to display the "Address Book" window.
6. Select the touchpanel from the address book or click Add Entry and type a
new name for the new device, such as TPS.
7. Click TCP as the connection type. Enter the IP address or hostname of the
touchpanel and click OK.
"Address Book" Window – TCP/IP Setup
8. Click Tools | System Info to display the "System Info" window. From the
pull-down menu, select the entry created in step 7.
If the touchpanel is to communicate with a control system over TCP/IP, an IP table
must be created on the touchpanel to identify the control system(s) it will
communicate with over TCP/IP.
Use the following instructions to create the IP table.
1. Select Functions | IP Table Setup from the Toolbox menu bar.
®
Crestron Isys TPS-12G/15G-QM-L
SIGNAL TO PIN
Tx+ 1
Tx- 2
Rc+ 3
Rc- 6
SIGNAL TO PIN
Rc+ 3
Rc- 6
Tx+ 1
Tx- 2
Operations Guide – DOC. 6356
SIGNAL
Tx+
Tx-
Rc+
Rc-
SIGNAL
Tx+
Tx-
Rc+
Rc-