Industry Compliance - Crestron TPS-12 Operation Manual

Wall Mount Touchpanels
14 ¥ Wall Mount Touchpanels: TPS-12G/15G-QM-L
NOTE: When transmitting S-video, luminance uses the green video pathway, and
chrominance uses the red video pathway. When transmitting composite video, the
signal is carried on the blue video pathway.
NOTE: Use CresCAT-QM, to make QM connections. The cumulative skew over
the entire length must be less than 22 ns. Refer to "QuickMedia Network Wiring" on
page 16 for cable specifications.
NOTE: When using CresCAT-QM wiring, four additional wires are included for
making Cresnet connections. Refer to "QuickMedia Network Wiring" on page 16 for
cable specifications.
Pushbuttons
Five pushbuttons are located on front, below the touchscreen, as shown in the
following diagram. The leftmost button is recessed and is a hard reset used to reboot
the touchpanel. The other four buttons are programmable. Refer to page 42 for hard
button programming information.
TPS-12G/15G-L Pushbuttons

Industry Compliance

As of the date of manufacture, the TPS-12G-QM-L, and TPS-15G-QM-L have been
tested and found to comply with specifications for CE marking and standards per
EMC and Radio communications Compliance Labeling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
®
Crestron Isys TPS-12G/15G-QM-L
Operations Guide – DOC. 6356