Crestron TPS-12 Operation Manual page 16

Wall Mount Touchpanels
LAN
12 ¥ Wall Mount Touchpanels: TPS-12G/15G-QM-L
LAN
One 8-wire RJ-45 connector with two LED indicators (green LED indicates link
status, yellow LED indicates Ethernet activity). This connector provides an Ethernet
10baseT /100baseTX, full duplex, TCP/IP, UDP/IP, CIP, DHCP, IEEE 802.3U
compliant network connection.
Network Connector Pinout
PIN SIGNALS
1 TX +
2 TX -
3 RC+
4 N/C
5 N/C
6 RC -
7 N/C
8 N/C
24VDC
One 24 Volt DC power jack (PW-2420RU power supply optional) powers the
TPS-12G-QM-L touchpanel in lieu of Crestnet power.
NET
The four-pin 5 mm detachable terminal block provides communication with and
power from a Cresnet control network. For additional details, refer to "Network
Wiring" on page 15. A cable for this connection is provided with the touchpanel.
Pins 24 and G provide 24 VDC and ground respectively. Power supply CNWPS-75
or C2N-SPWS300 can also be used to power the TPS-15G-QM touchpanel.
Pins Y and Z provide communications (data).
USB
Two Universal Serial Bus (USB) "A" connectors provide a communications link.
USB is a connectivity specification developed by the USB Implementers Forum
that provides a single, simple, standardized way to connect devices to a computer.
USB shielded cables contain two wires for power +5 volts (red) and ground
(brown) and a twisted pair of wires (yellow and blue) that carry data.
USB Type A Connector Pinout
PIN DESCRIPTION
1 +5 VDC
2 Data -
3 Data +
4 Ground
®
Crestron Isys TPS-12G/15G-QM-L
NOTE: This connector is reserved for
future applications.
Operations Guide – DOC. 6356