Installing The Discharge Tubes - Toro 30460 Operator's Manual

11

Installing the Discharge Tubes

Parts needed for this procedure:
1 Upper tube
1 Middle tube
1 Lower tube
6 Bolt, (#10 x 3/4 inches)
6 Locknut, (#10)
6
Washer, (7/32 inch)
Procedure
Important: Make sure the mower deck is in the lowest
height-of-cut position while installing the discharge
tubes.
1. Lower the mower deck to the lowest height-of-cut
position.
2. Install the lower tube into the middle tube so there is
63.5 mm (2-1/2 inches) of overlap
Figure 20
1. Lower tube
2. Middle tube
3. Using the three holes or indentations in the middle tube
as a template, drill 3 holes (7/32 inch diameter) where
the lower and middle tubes join together
4. Loosely install the lower and middle tubes with 3 bolts
(#10 x 3/4 inches), 3 flat washers (7/32 inch), and 3
locknuts (#10) (Figure
(Figure 20).
3. 63.5 mm (2-1/2 inches) of
overlap
4. Existing holes in the
middle tube
(Figure
21).
1. Lower tube
2. Middle tube
3. Drill 7/32 inch diameter
holes here (use upper tube
as a template)
5. Install the upper tube into the bagger opening and pull
it back out so the rubber seal is protruding out
22 and Figure
1. Upper tube
2. Bagger opening
6. Measure the distance the tube is inside the hood.
Measure from the hood plate to the edge of the tube
as shown in
inch (19 mm).
21).
14
Figure 21
4. Flat washer, (7/32 inch)
5. Locknut, (#10)
6. Bolt, (#10 x 3/4 inches)
24).
Figure 22
3. Bagger hood
Figure 23. This distance needs to be 3/4
(Figure