Preparing The Mower; Installing The Pulley Assembly - Toro 30460 Operator's Manual

Note: Determine the left and right sides of the machine from the normal operating position.
1

Preparing the Mower

No Parts Required
Procedure
Perform the following procedure to prepare the mower for
attaching the blower and finishing kit.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Repair all bent or damaged areas of mower deck and
replace any missing parts.
4. Clean the mower of any debris on the deck or rear part
of the mower to ease installation.
2

Installing the Pulley Assembly

Parts needed for this procedure:
1 Double pulley assembly
1 Pulley nut
Procedure
1. Lower the mower deck to the lowest height-of-cut
position.
2. Remove the right belt cover. Save this cover.
3. Remove the mower deck belt from the right pulley.
4. Place a block under the right blade spindle under
the mower deck before removing the right mower
deck pulley (Figure
components dropping down when the pulley nut is
removed.
5. Remove the existing pulley nut and remove the pulley
(Figure 3). Save the pulley and nut for later use.
6. Install the new double pulley onto the spindle and
secure it with the new pulley nut
nut to 130-150 ft-lb (176-203 N-m).
7. After the new pulley assembly is in position, install the
mower deck belt onto the lower pulley.
3). This will prevent the spindle
(Figure 3). Torque the
1. New pulley nut
2. Double pulley assembly
6
Figure 3
3. Mower deck