Table of Contents
Advertisement
Adjusting the Door Opening
Perform this after adjusting the door closing.
Adjust the handle link to obtain the maximum door opening.
Lengthen the handle link to open the door farther. Shorten
the handle link to open the door less
42).
Note: The maximum door opening is controlled by the
contact arm hitting the stop. The stop is not adjustable and
prevents the door from being opened too far.
1. Handle
2. Handle link
1. Bagger arm assembly
2. Bagger handle linkage
(Figure 41
and
Figure 41
3. Stop
Figure 42
3. Clevis pin spring
4. Bagger assembly
Adjusting the Latches
The latches can be adjusted after the open and closed door
positions have been set.
1. Disengage the PTO, move the motion control levers to
the neutral locked position, and set the parking brake.
Figure
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Close the door.
4. Check the to ensure the latches completely engage and
contacts the latch rod welded to the door
5. The latches need to be tight against the latch rod, but
need to be loose enough to move or wiggle.
1. Latch link
Inspecting the Mower Blades
1. Inspect the mower blades regularly and whenever a
blade strikes a foreign object.
2. If blades are badly worn or damaged, install new blades.
Refer to your mower Operator's Manual for complete
blade maintenance.
25
(Figure
Figure 43
2. Latch rod
43).
Advertisement
Table of Contents
