Table of Contents
Advertisement
Note: Install the bolt heads on top of the mower.
7. Install the belt guard (Fig. 13).
2
1
2 3
5
4
m–5964
Figure 13
1. Template
2. Hole to drill
3. Existing hole
4. Mower
Installing the Discharge Tubes
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Lift the grass deflector all the way back. This will
eliminate interference with the boot (Fig. 14).
4. Align the boot with the boot bracket (Fig. 14).
5. Install the boot pin through the boot and boot bracket
and secure with a hair pin cotter (Fig. 14).
6
7
5. Grass deflector
6. Re–enforcement plate
7. Belt guard
10
7
Figure 14
1. Boot
2. Boot Pin
3. Hairpin cotter pin
4. Grass deflector
6. Slide the middle tube onto the boot and latch them
together (Fig. 15).
7. Install the upper tube into the collector and onto the
middle tube (Fig. 15).
Figure 15
1. Boot
2. Middle tube
8. Using the upper tube as a template, mark the hole
locations on the middle tube (Fig. 16).
9. Remove the upper tube and middle tube.
10. Drill 3 holes, 9/32 in. diameter, into the middle tube
(Fig. 16).
11. Install the middle and upper tube with 3 carriage bolts
(1/4 x 3/4 in.) and 3 flange nuts (1/4 in.) (Fig. 16).
Important
Make sure the bolt heads are on the inside
of the middle tube.
12. Install the upper and middle tube to collector and boot.
(Fig. 15).
3
6
2
5
4
1
m-5962
5. Boot bracket
6. Bolt, 1/4 x 1/2 in. and
flange nut, 1/2 in.
7. Slots in boot
4
3
2
1
m-5945
3. Upper tube
4. Collector
Advertisement
Table of Contents
