Installing The Weight Kit; Checking The Tire Pressure - Toro 30460 Operator's Manual

Figure 30
1. 6 inch (152 mm)
height-of-cut hole
2. Nut (1/2 inch)
13

Installing the Weight Kit

No Parts Required
Procedure
®
The GroundsMaster Traction Unit with the bagger installed
complies with ANSI B71.4-2012 when the weight kit is
installed. Order the appropriate weight kit from your local
Authorized Toro Distributor.
Install the kit with the instructions included in the kit.
CAUTION
The bagger adds a lot of weight to the rear of the
machine and may cause an unstable condition
which could result in a loss of control.
Ensure the weight kit is installed.
3. Bolt (1/2 x 2-1/2 inches)
14

Checking the Tire Pressure

No Parts Required
Procedure
Note: Increase the tire pressure due to the additional weight.
Check and increase the air pressure in the front caster wheels
and rear tires (Figure 31).
Pressure: Rear tires–20 psi (138 kPa)
Front caster wheels–30 psi (172 kPa)
17
Figure 31