Toro 30460 Operator's Manual page 11

Figure 11
1. Lower mounting bracket
2. Hook
3. Bagger on it's back
6. Install the nuts and yokes onto the threaded rod
12).
7. Adjust the yokes until the center of the holes are 9
inches (228.6 mm) apart
4. Rotate bagger up
5. Hairpin cotter pin
connected to lanyard
6. Pin connected to lanyard
(Figure
(Figure 12).
1. Yoke
2. Nut
8. Tighten the nuts against the yokes.
9. Install the yokes to the bagger assembly and handle and
secure it with 2 clevis pin springs
10. Rotate the bagger handle linkage up to the bagger
assembly and secure it with a clevis pin spring
13). Loosen and rotate the yoke if needed to align with
the bagger assembly.
1. Bagger arm assembly
2. Bagger handle linkage
11
Figure 12
3. Threaded rod
4. 9 inches (229 mm) apart
(Figure 13).
Figure 13
3. Clevis pin spring
4. Bagger assembly
(Figure