Table of Contents
Advertisement
3. Close the blower assembly to see if the latches are
adjusted correctly.
Note: Loosen or tighten the bolt so the latches firmly
hold the blower assembly against the mower deck, but
can be released by hand
Figure 19
1. Latch
2. Bolt
4. Install the spring as shown in
Note: Make sure that the hooks are in the correct
position.
Figure 20
1. Spring-loaded idler pulley
2. Short-hook end
(Figure
19).
3. Blower assembly
Figure
20.
3. Long-hook end
5. Pull the spring-loaded idler pulley back and route the
belt around the mower-deck pulley.
Note: Ensure that the belt is routed around the blower
pulleys correctly
1. Mower-deck pulley
2. Spring-loaded idler pulley
8
Installing the Discharge Tubes
Parts needed for this procedure:
1
Upper tube
1
Lower tube
3
Bolt (#10 x 3/4 inches)
3
Locknut (#10)
3
Washer (7/32 inch)
Procedure
Important: Make sure that the mower deck is in
the lowest height-of-cut position while installing the
discharge tubes.
Note: Remember to replace the grass deflector when the
bagger is removed from the machine. Refer to
Grass Deflector (page
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Lower the machine deck to the lowest height-of-cut
position.
4. Remove the bags for viewing the tube under the hood.
12
(Figure
21).
Figure 21
3. Blower
Replacing the
26).
Advertisement
Table of Contents
