Toro 30460 Operator's Manual page 13

Figure 16
1. Blower assembly
2. Mower deck
3. Close the blower assembly to see if the latches are
adjusted correctly. Loosen or tighten the bolt so the
latches firmly hold the blower assembly against the
mower deck, but can be released by hand
Figure 17
1. Latch
2. Bolt
4. Install the spring as shown in
Note: Make sure the hooks are in the correct position.
3. Pivot hole
4. Blower assembly peg
(Figure 17).
3. Blower assembly
Figure 18.
1. Spring loaded idler pulley
2. Short hook end
5. Pull the spring loaded idler pulley back and route the
belt around the mower deck pulley. Ensure the belt is
routed around the blower pulleys correctly
1. Mower deck pulley
2. Spring loaded Idler pulley
6. Tighten the latch bolts.
13
Figure 18
3. Long hook end
(Figure
Figure 19
3. Blower
19).