Removing The Existing Anti-Scalp Roller And Bracket; Installing The Blower Pivot For A 60 Inch Bagger - Toro 30460 Operator's Manual

3
Removing the Existing
Anti-Scalp Roller and Bracket
No Parts Required
Procedure
1. Clean the area around the right, rear anti-scalp wheel.
2. Remove the anti-scalp roller from the bracket by
loosening and removing the flange nut (3/8 inch) and
axle bolt (3/8 x 4-1/2 inch) as shown in
all hardware for later use.
3. Remove the three carriage bolts (3/8 x 3/4 inch) and
flange nuts (3/8 inch) securing the bracket to the
mower (Figure 4).
Note: Save all hardware for later use.
1. Anti-scalp roller
2. Anti-scalp bracket
3. Bolt, (3/8 x 4–1/2 inch)
Figure
Figure 4
4. Carriage bolt, (3/8 x 3/4
inch)
5. Flange nut, (3/8 inch)
6. Mower deck
4
Installing the Blower Pivot for
a 60 inch Bagger
Parts needed for this procedure:
1 Blower pivot
1 Metal template
3
Bolt (3/8 x 1 inch)
3 Locknut (3/8 inch)
4. Save
Procedure
1. Install the metal template, with the number 60 in it, to
the mower deck with the previously removed carriage
bolts and nuts using the existing holes in the mower
deck (Figure
Make sure the carriage bolts and nuts are tight and the
template is tight against the mower deck.
2. Center punch the new mower deck hole locations using
the 3 holes in the template
3. Remove the metal template and drill three, 1/8 inch
diameter, pilot holes with a sharp drill bit
4. Drill three, 13/32 inch diameter, holes into the pilot
holes with a sharp drill bit
7
5).
(Figure 5).
(Figure 5).
(Figure 5).