Troubleshooting - Toro 30460 Operator's Manual

Troubleshooting

Problem
Abnormal vibration.
Reduced bagging performance.
Blower and tubes plug too frequently.
Debris blowout.
Blower impeller does not spin freely.
Possible Cause
1. Cutting blade(s) is/are bent or
unbalanced.
2. Blade mounting bolt is loose.
3. Loose blower pulley or pulley
assembly.
4. Worn blower belt.
5. Blower fan blade(s) is/are bent or
unbalanced.
1. Low engine speed.
2. Plugged screen in bagger hood.
3. Loose blower belt.
4. A plugged tube or blower.
5. Full bagger.
1. Bagger is too full.
2. Low engine speed.
3. Grass is too wet.
4. Grass is too long.
5. Plugged screen in hood.
6. Ground speed is too fast.
7. Worn blower belt.
1. Bagger is too full.
2. Ground speed is too fast.
3. Mower deck is not leveled.
1. Plugged blower.
2. Impeller not aligned.
28
Corrective Action
1. Install new cutting blade(s).
2. Tighten the blade mounting bolt.
3. Tighten the appropriate pulley.
4. Replace belt.
5. Contact an Authorized Service Dealer.
1. Always operate the collection system
at full throttle.
2. Remove debris, leaves or grass
clippings from the screen.
3. Replace the blower belt.
4. Locate and remove plugged debris.
5. Empty the bagger.
1. Dump more frequently.
2. Always operate the collection system
at full throttle.
3. Cut grass when it is dry.
4. Cut no more than 2-3 inches (51-76
mm) or 1/3 of the grass height, which
ever is less.
5. Remove debris, leaves or grass
clippings from the screen.
6. Drive slower at full throttle.
7. Replace belt.
1. Dump more frequently.
2. Drive slower at full throttle.
3. See the mower operator's manual for
leveling the mower deck.
1. Remove debris, leaves or grass
clippings from the blower impeller.
2. Contact an Authorized Service Dealer.