To Run Configuration Wizard In A Domain; To Change The Computer Name - Nortel T1/SMDI Configuration Manual

Configuring the CallPilot server software
3 When you dial in to the server, the system prompts you for a dial-in
domain user account and password. Enter the username and password
that you received in Step 1.
Note: This option manages the user account in one location, for both
dial-in access through pcAnywhere or RDC.

To run Configuration Wizard in a domain

After you add the CallPilot server to a domain, the domain account that is
used to log on to the CallPilot server does not have network administrator
privileges. As a result, if you run the Configuration Wizard after you add
your CallPilot server to the domain, two procedures do not work until you
remove the server from the domain. The two procedures are: changing the
computer name, and changing the local administrator account and the local
CallPilot NGen accounts. To perform these two procedures when your
server is in a domain, you must remove the server from the domain, perform
the procedure, and then add the server to the domain again.

To change the computer name

To change the computer name when you run Configuration Wizard and
CallPilot is a member of a domain, perform the following steps:
1 Ask your network administrator to remove the CallPilot server from the
domain and add the server to a workgroup. You can also perform this
step on your own, if you acquire network administrator privileges from
your network administrator.
2 Shut down and restart the CallPilot system.
3 Run the Configuration Wizard and select the option to change the
computer name.
4 Shutdown and restart the CallPilot system.
5 Ask your network administrator to add the CallPilot server to the domain.
You can also perform this step on your own, if you acquire network
administrator privileges from your network administrator.
6 Shutdown and restart the CallPilot system.
130
Standard 1.13
CallPilot