Table of Contents
Advertisement
February 2008
Installation and configuration checklist
Complete the steps in each chapter before you continue to the next chapter.
Step Description
Stage 1: Install the hardware to connect the CallPilot server to the
switch or system.
1
Connect the CallPilot server to the T1/SMDI switch or system.
For instructions, depending on the type of switch or system you
have, see Chapter 3, "Connecting the CallPilot server to the
switch," on page 31.
Stage 2: Configure the switch or system and CallPilot server.
2
Configure the T1/SMDI switch or system.
Note: Use the "Switch or system configuration worksheet" that
you completed in the CallPilot Installation and Configuration
Task List.
For configuration instructions, see Chapter 4, "Configuring the
switch," on page 53.
3
Log onto the CallPilot Server. The Setup Wizard launches
automatically and guides you through installing Service Updates
(SUs) and Performance Enhancements Packages (PEPs), if
updates are required.
4
Run the Configuration Wizard to configure the CallPilot server.
Use the "Configuration Wizard worksheet" that you completed in
the CallPilot Installation and Configuration Task List.
For configuration instructions, see Chapter 5, "Configuring the
CallPilot server software," on page 99.
T1/SMDI and CallPilot Server Configuration
CallPilot and T1/SMDI connectivity overview
Check
❒
❒
❒
❒
17
Advertisement
Table of Contents
