Juniper JSA5800 Hardware Manual page 43

NOTE: When using a laptop to connect to the appliance, you must use a terminal program, such
as HyperTerminal, to connect to the appliance.
1. At the console prompt, log in as root (default username). No password is required when you log in
for the first time.
NOTE: The username is case sensitive.
2. Press Enter. The End User License Agreement (EULA) appears.
3. Read the information and press the Spacebar to advance each window until you have reached the
end of the agreement.
4. Type YES to accept the agreement, then press Enter. The Appliance ID selection window appears.
NOTE: Although your current position is not highlighted, use the up or down arrow keys and
Spacebar to select an option. Use the left or right arrow keys to select Next.
5. Select the appliance ID and then press Enter to select Next.
6. Select normal from the following types of setup:
normal —Default setup
•
recovery —HA recovery setup
•
7. Select Next. The Tuning Template window appears.
8. Select Enterprise and then select Next. The Date and Time window appears.
9. Select the method you want to use to set the date and time:
Manual –Allows you to manually input the date and time. Select Next.
•
Server –Allows you to specify your time server. Select Next.
•
10. Select your time zone continent or area, and then select Next.
11. Select your time zone region, and then select Next. The options appearing in this window are
regions associated with the continent or area previously selected.
12. Select one of the following Internet protocols, IPv6 or IPv4.
13. Select Next. The Management Interface window appears.
14. Select the interface you want to specify as the management interface and select Next.
15. To configure the JSA network settings, enter the values for the following parameters. Use the up or
down arrow keys to navigate the fields:
Hostname —Type a fully qualified domain name (FQDN) as the system hostname.
•
37