Juniper JSA5800 Hardware Manual page 33

a. Pull the inner rail out of the outer rail until it is fully extended as illustrated. Press the locking tab
down to release the inner rail, as shown in
that secures the chassis when completely extended from the rack.
Figure 8: Sliding and Detaching the Inner Rails
b. Place the inner rails against the sides of the chassis, aligning the chassis hooks with the holes in
the inner rails, as shown in
c. Slide the inner rail toward the front of the chassis until the inner rail clicks into the locked
position.
d. Secure the inner rails to the chassis with the screws provided.
Figure 9: Installing the Inner Rails
NOTE: Each inner rail of the JSA5800 appliance has a locking tab. The locking tabs secure the
chassis when it is either installed or completely extended from the rack.
2. Install the outer rails:
a. Press the locking tabs upward at the rear of the middle rails, and slide the middle rails into the
outer rails.
Figure 8 on page
Figure 9 on page 27.
27. Each inner rail has a locking tab
27