Juniper JSA5800 Hardware Manual page 44

IP Address —Specify the IP address of the system.
•
Netmask —Specify the network mask address for the system.
•
Gateway —Specify the default gateway for the system.
•
Primary DNS —Specify the primary DNS server.
•
Secondary DNS —(Optional) Specify the secondary DNS server.
•
• Public IP —(Optional) Specify the public IP address of the server. The server uses this IP address
to communicate with another server that belongs to a different network using Network Address
Translation (NAT). NAT translates an IP address in one network to a different IP address in
another network.
Email Server —Specify the e-mail server. If you do not have an e-mail server, specify the local
•
host in this field.
16. Use Tab to select Next. Press Enter. The New Root Password window appears.
17. To configure the JSA root password:
a. Type a new password.
b. Select Next and then press Enter. The Confirm New Root Password window appears.
c. Reenter your new password to confirm, and select Finish.
A series of messages appears as JSA continues with the installation; this process takes from
three to five minutes. When the JSA installation process is complete, the message window
appears.
18. Press Enter and select OK to complete the installation.
You are now ready to access JSA. For more information, see
19. Type exit and press Enter.
SEE ALSO
Accessing the JSA Interface | 0
JSA5800 Appliance Physical Specifications | 0
Connecting the JSA5800 Appliance to a Management Device | 35
Accessing the JSA Interface
38
.