Ember Material Installation; Ember Installation; Rock Wool Placement (All Models) - Lopi ProBuilder 24 CleanFace GSR2 Installation Manual

Ember Material Installation


Once the ember glass installation is complete, place a generous amount of ember material on the firebox floor
on either side of the firebox. Completely cover any visible metal on the firebox floor.
NOTE: Make sure no ember material is placed directly on the burner.
HINT: Add a few randomly placed ember chunks over the ember bed glass to produce a more realistic appearance.

Ember Installation

A bag of embers is provided to further enhance
the firebox. Place the embers on the firebox floor
and on the burner. Do not place embers over any
of the burner holes or air channels.

Rock Wool Placement (All Models)

The included rock wool is placed on top of the burner to enhance the glow from the burner. The rock
wool works best when it is applied in a very thin layer. The best method for applying the rock wool is
to brush it on to the burner. Compress a clump of rockwool between your thumb and forefinger. Use a stiff
brush to apply a thin layer of rockwool fibers onto the burner. Do not use the entire bag of rockwool. Use
only a small amount and save the remainder. Over-use of rockwool will diminish the glow and may cause
sooting or other adverse conditions.
© Travis Industries
Installation
(for qualified installers only)
12/17/20 - 1528
55
PB24 CF Install (AUST)