Thin Facing (1/2" (13Mm) To 1-1/2" (38Mm)); Screen Assembly Mounts - Lopi ProBuilder 24 CleanFace GSR2 Installation Manual

38

Thin Facing (1/2" (13mm) to 1-1/2" (38mm))

When using thin facing you may remove the thick facing guide and tuck the facing underneath the screen
assembly. The screen assembly mounts may be adjusted to position the screen assembly directly
against the facing (see "Screen Assembly Mounts" below). To further illustrate this, note how the screen
assembly mount is moved forward in the 1" (26mm) facing example below).
Screen assembly mount
may be slid forward to
accommodate facing.

Screen Assembly Mounts

The screen assembly mounts (located on outer front edges of the fireplace) are adjustable to allow the
screen assembly to be positioned 1/2" (13mm) to 1-1/2" (38mm) from the front of the fireplace. This
allows facing to tuck under the screen assembly. Each mount is held in place by (3) Philips head screws.
Before mounting the screen assembly, adjust the mounts so that the front edge is flush with the finish
material surrounding the fireplace. To adjust the mounts, loosen the screws, slide the mounts to the
desired position, and then tighten the screws.
© Travis Industries
Installation
(for qualified installers only)
Thin Facing (1/2" 13mm) - Top View
Phillips
Screwdriver
Thick Facing (1" 26mm) - Top View
Fireplace
Screen Assembly
Mount
Fireplace
Screen Assembly
Mount
Position edge of mount
flush with finish material
12/17/20 - 1528
Framing
Drywall
Max. 1/2" (13mm) Overlap
Framing
Drywall
Max. 1/2" (13mm) Overlap
PB24 CF Install (AUST)