Header and Pipe Shield Installation
The header and pipe shield must be installed as shown below.
NOTE: The header and pipe shields may be installed after the fireplace is in place and vent attached (this
allows for the fireplace to fit into the framing underneath the header and for the vent to be installed more
easily).
1
At each of the perforations, bend the sides of the pipe shield backward 90° as shown below.
NOTE: The bottom flanges should be facing outward
Bend at perforations
2
Remove the (4) screws, (2) from each side of the starter collar. Line up the holes on the pipe
shield tabs with the holes from the screws you just removed. Use the screws to attach the pipe
shield to the top of the fireplace.
Remove screws
© Travis Industries
Installation
(for qualified installers only)
12/17/20 - 1528
Tabs face out.
PB24 CF Install (AUST)
13