Installation Options; Features; Heating Specifications; Dimensions - Lopi Evergreen NexGen-Fyre Insert Manual

6 Fireplace Insert Installation

Installation Options


Masonry Fireplace Insert

Zero-Clearance (Metal) Fireplace Insert

Heating Specifications

Approximate Maximum Heating Capacity (in square feet)*
EPA Tested Cord Wood BTUs per Hour**
Maximum Burn Time
* Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside temperature.
It is also affected by the quality and moisture level of the fuel.
** EPA tests to determine BTU output are achieved with a single load of wood at each burn rate. At home, you
are likely to add more wood to your stove to maintain your desired comfort level. By the simple process of loading
your stove with additional wood, you could achieve up to a 20% higher heat output than established during EPA
testing.
This model was tested for efficiency using method B415.1-10 and was determined to have a weighted average
Higher Heating Value (HHV) Overall Heating Efficiency (OHE) of 77.1%. Overall efficiency of the heater may be
lower if the heater is operated without a heat exchange blower or with the installed heat exchange blower turned off.

Dimensions

Emissions

This heater meets the 2020 U.S. EPA's cord wood emission limits for wood heaters. Tested to EPA Alt-125,
ASTM E3053-17, ASTM 2515-11, CSA B415.1-10 this heater has been shown to deliver heat at rates
ranging from 12,772 to 70,720 BTU/hr and an emission value of 1.52g/h. Report No. 0028WS119E
© Travis Industries
(for qualified installers only)

Features


Single Operating Control

Steel Plate Construction (1/4" & 3/16")

Heavy Duty Refractory Firebrick

Optional High-Tech Blower
11/5/2021 - 1560
up to 2,000 (185 square meters)
12,772 to 70,720
Up to 10 Hours
Evergreen Insert