Lopi ProBuilder 24 CleanFace GSR2 Installation Manual page 26

26
c. Use a ¼" nut driver to remove
the (2) screws that secure the
Ember-Glo light assembly to
the log grate and slide the
light assembly forward. (set
the screws aside for
reinstallation).
d. Loosen the (2) screws that
secure the log grate assembly
to the back wall of the firebox
and remove the 2 screws that
secure it to the floor of the
firebox. Lift slightly on the
grate assembly and remove it
from the fireplace.
e. The intake restrictor is now
visible on the lower rear of the
firebox. Loosen the (2)
screws and slide the restrictor
all the way down. Tighten the
screws to secure the
restrictor.
Follow the steps above in reverse
to return the fireplace to the
correct configuration.
© Travis Industries
Installation
(for qualified installers only)
12/17/20 - 1528 PB24 CF Install (AUST)