Removing And Installing Automatic Gearbox Control Unit; Removing; Install - Skoda Fabia II 2007 Workshop Manual

Removing

Caution
Observe measures when disconnecting and connecting the
battery ⇒ Electrical System; Rep. gr. 27 .
Touch an earthed object before working on the electrical com‐
ponents. Do not grab directly at the plug contacts or electronic
components.
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System; Rep. gr. 27 .
– Unlock the plug connection from the gearbox control unit and
disconnect.
– Press off locking tabs -arrows- from control unit holder.
– Remove control unit from the top.
Note
The adaptation values in the gearbox control unit are reset when
the plug connection is separated. The control unit must re-initial‐
ise these values after the re-connection. During this "initialisation"
the gearshift quality can be worse than usual.

Install

– Insert the control unit into the mounting bracket at the battery
cover until it clicks into the position of the locking tabs
-arrows-.
– Mount the plug connection of the gearbox control unit.
– Connect earth strap of battery ⇒ Electrical System; Rep. gr.
27 .
1.2.3 Removing and installing automatic gear‐
box control unit (YETI) - J217-
Fitting location: The control unit is located at the battery cover in
the engine compartment.
Removing
Caution
Observe measures when disconnecting and connecting the
battery ⇒ Electrical System; Rep. gr. 27 .
Touch an earthed object before working on the electrical com‐
ponents. Do not grab directly at the plug contacts or electronic
components.
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System; Rep. gr. 27 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
1. Electric and electronic components, fitting locations of the automatic gearbox
Gearbox 09G - Edition 07.2014
39