Skoda Fabia II 2007 Workshop Manual page 165

– Connect hoses of ATF radiator according to the markings onto
the ATF radiator.
Note
Depending on the as-built configuration a small plastic tube is lo‐
cated in the feed of the ATF radiator, which must be re-installed
during installation.
– Check coolant level in the cooling system ⇒ Engine; Rep. gr.
19 .
– Inspecting ATF level and if necessary topping up
⇒ "4.1 Check the ATF level level and top up", page 147
Tightening torques
Component
ATF radiator to gearbox
5.2.2 Remove and install ATF radiator (Octa‐
via IlI)
Special tools and workshop equipment required
♦ Hose clamp - MP7-602 (3094)-
Removing
– Remove engine cover ⇒ engine; Rep. gr. 10 .
– Remove air filter ⇒ Engine; Rep. gr. 24 .
Caution
Observe measures when disconnecting and connecting the
battery ⇒ Electrical System; Rep. gr. 27 .
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
– Mark hoses of ATF radiator in order to prevent interchanging
when installing.
– Unlock the quick-release lock -2- and unhook the selector lev‐
er control cable -1-.
Caution
♦ When the engine is warm, the cooling system is under
overpressure.
♦ Before removing the coolant hoses, cover the cap of the
coolant expansion tank with a cloth and open it carefully.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Nm
⇒ "5.1 ATF radiator -
Summary of compo‐
nents", page 155
Gearbox 09G - Edition 07.2014
.
161
5. ATF coolant circuit