Removing And Installing Retractor Spring - Skoda Fabia II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
– Pull the cover -B- upwards over the handle.
– Disconnect plug -A- for lamp for selector lever scale illumina‐
tion - L101- .
– Open the warm-type clamp -arrow- below the handle and pull
off handle with cover.
Install
Installation is carried out in the reverse order. When installing,
observe the following:
Note
The lock button must be fully pulled out for installing the se‐
♦
lector lever handle. Then the grip must be secured using a
cable strap -arrow- or with the factory-delivered assembly aid
for the new grip.
If the lock button was not inadvertently secured, it must not be
♦
pulled out of the selector lever grip using mechanical auxiliary
tools if it is pressed in. The lock button can be pressed out if
necessary by positioning the compressed air pistol on the un‐
derside of the grip.
– Insert the selector lever with a new clamp onto the selector
lever fully until the stop.
• During this procedure, the grip must latch in the annular
groove of the selector lever.
• The handle must be rotated with the lock button to the driver.
– Remove the cable strap or the assembly aid. After the remov‐
al, the lock button actuator grips into the vertical groove of the
selector lever, if necessary press the lock button into the se‐
lector lever grip.
Tighten warm-type clamp -arrow- using the hose binding claw .
– Installing the cover for the shift mechanism
⇒ "2.5.3 Removing and Installing the cover for the shift mech‐
anism Octavia II", page 60
2.6.2

Removing and installing retractor spring

Superb II
Special tools and workshop equipment required
♦ Hose binding claw - V.A.G 1275-
66
Rep. gr.37 - Controls, housing
.