Skoda Fabia II 2007 Workshop Manual page 190

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
– Bend back the hooks of the circlip -2- using a screwdriver.
Note
If one or several hooks of the circlip break off by bending, the
circlip must be replaced ⇒ Electronic Catalogue of Original Parts .
– Remove nut -3- with washers -2- and -1-.
– Unscrew the 2 screws -B- and pull off the multi-function switch
-A- upwards over the gearshift shaft.
Install
Installation is carried out in the reverse order. Pay attention to the
following:
– Fit the multi-function switch - F125- onto the gearshift shaft.
– Tighten the fixing screws -B- for multi-function switch by hand.
– Fit washers -1-, -2- and nut -3- onto the gearshift shaft.
– Secure the nut by bending up the hooks to the circlip -2-.
Note
If one or several hooks of the circlip break off by bending, the
circlip must be replaced ⇒ Electronic Catalogue of Original Parts .
– Setting multi-function switch - F125-
⇒ "2.2 Setting multi-function switch F125 ", page 187
– Install gearshift lever -1-.
Note
The gearbox must remain in the position "N", if necessary shift
back into "N".
186
Rep. gr.38 - Gears, control
.