Skoda Fabia II 2007 Workshop Manual page 122

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
Note
If the battery earth strap is disconnected and connected, carry
♦
out additional operations ⇒ Electrical System; Rep. gr. 27 .
All cable straps which are detached or cut open when remov‐
♦
ing, should be fitted on again in the same place when installing.
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System; Rep. gr. 27 .
– Disconnect plug from automatic gearbox control unit -J217- .
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
– Remove intake hose ⇒ Engine; Rep. gr. 24 .
– Lever off the selector lever control cable -2- from gearshift
lever e.g. using an open-end wrench -1-.
– Press together the catches at the cable support of the selector
lever control cable -arrows- and pull out the selector lever
control cable from the cable support/gearbox.
– Unplug connector -3-.
– Unscrew the cable support for the selector lever control cable
from the gearbox.
– Unscrew earth strap -3-.
– Detach cables -1- and -2- at starter and expose.
– Mark hoses of ATF radiator to ATF radiator, in order to prevent
interchanging when installing.
Note
Depending on the as-built configuration a small plastic tube is lo‐
cated in the feed of the ATF radiator, which must be re-installed
during installation.
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Clamp off the ATF-radiator hoses with hose clamps - MP7-602
(3094)- and remove from ATF-radiator.
– Close ATF-radiator with a clean plug.
– Release all connecting screws of the engine/gearbox acces‐
sible from the top.
Installation positions: ⇒ "3.3 Tightening torques ", page 134
118
Rep. gr.37 - Controls, housing
.