Skoda Fabia II 2007 Workshop Manual page 179

Note
Observe when installing that the screws have different lengths
♦
and must be replaced.
Only the marked fixing screws -arrows- must be released.
♦
When releasing other screws the function of the slide valve
♦
body can be impaired or the slide valve body splits.
When removing the slide valve body, the shock absorber pis‐
♦
ton -E- must be secured against dropping out or removed
together with both springs.
Install
Note
The routing of the cables must be accurately observed, so that
♦
when positioning the slide valve body they are not trapped or
damaged.
Damaged or trapped cables must always be replaced.
♦
– Route the wiring loom -C- (with 8-pin plug) according to the
illustration in the specified recess in the slide valve body.
• The wiring loom -C- must not rest against the planetary gear‐
box. The clearance -a- must be maintained, so that the wiring
loom is not chafed in the driving mode.
– Route the wiring looms -A-, -B- and -D- according to the illus‐
tration over the gearbox border.
– Make sure that the shock absorber piston -E- is installed in the
illustrated location in the gearbox.
Note
If the shock absorber piston -E- was removed, is must be
♦
cleaned together with both springs and installed according to
the illustration
⇒ "1.2 Summary of components - oil pan, oil strainer, slide
valve body, internal wiring looms", page 165
and Pos. 25.
To do so insert both springs into each other, coat the outer wall
♦
of the shock absorber piston and the opening in the gearbox
with ATF and insert all parts in the gearbox.
Press the shock absorber piston in the gearbox and secure
♦
against falling out, until the slide valve body is positioned.
– Position the slide valve body without force.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Pos. 27, Pos. 26
1. Removing and installing oil pan, oil filter, slide valve body and internal wiring looms
Gearbox 09G - Edition 07.2014
175