Inspecting And Adjusting The Selector Lever Control Cable - Skoda Fabia II 2007 Workshop Manual

When the gear selector lever is put into the Tiptronic gate, the
selector lever position display in the dash panel insert should
change from "PRNDS" to "654321".
– Move selector lever in the Tiptronic gear to "+" and "-".
When the gear selector lever is put into a higher or a lower driving
position, the selector lever position display in the dash panel in‐
sert should change.

– Inspecting and adjusting the selector lever control cable

⇒ "2.3 Inspecting and adjusting the selector lever control ca‐
ble", page 55 .
– Check ignition key anti-removal lock
⇒ "2.4 Check the function of the ignition key removal lock",
page 57 .
2.3 Inspecting and adjusting the selector
lever control cable
Inspection
– Shift selector lever into position "P".
– Remove engine cover ⇒ engine; Rep. gr. 10 .
For vehicles Octavia II and Superb II
– Remove air guide hose.
– Remove air filter ⇒ Engine; Rep. gr. 24 .
For vehicles Fabia II, Roomster and Rapid
– Remove automatic gearbox control unit - J217-
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
– Remove intake hose ⇒ Engine; Rep. gr. 24 .
For vehicles Octavia III
– Remove air filter ⇒ Engine; Rep. gr. 24 .
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
For the vehicles Yeti
– Remove automatic gearbox control unit - J217- with mounting
bracket
⇒ "1.2.3 Removing and installing automatic gearbox control
unit (YETI) J217 ", page 39
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
Continued for all vehicles
– Lever off the selector lever control cable -3- from gearshift
lever, e.g. using an open-end wrench -1-.
Note
Ignore position -2- and -4-.
For vehicles Fabia II, Roomster, Rapid, Octavia II and Superb II
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
.
Gearbox 09G - Edition 07.2014
⇒ page 38 .
2. Repairing shift mechanism
55