Rear Panel; Rear Panel Assembly - Sony HDCU3500 Service Manual

2-15.

Rear Panel

2-15-1.

Rear Panel Assembly

Preparation
1. Remove the top cover. (Refer to
2. Remove the DC fan. (Refer to
3. Remove the AC inlet. (Refer to
Procedure
1. Disconnect the two fine-wire coaxial cables from the connectors (CN2000 and CN2001) on the VIF-75 board.
(Refer to step 1 in "2-6. VIF-75
2. Disconnect the fine-wire coaxial cable from the connector (CN600) on the SY-467 board.(Refer to step 1 in
SY-467 Board/AT-195 Board".)
3. Disconnect the flexible flat cable from the connector (CN010) on the MB-1257 board.
4. Disconnect the flexible flat cable from the connector (CN005) on the MB-1257 board.
5. Open the clamper and locking wire saddle [A], and then remove the harnesses and three fine-wire coaxial cables.
6. Remove the three fine-wire coaxial cables from the locking edge saddle.
7. Open the locking wire saddle [B], and then remove the two harnesses.
Locking edge saddle
MB-1257 board
Fine-wire coaxial cables
HDCU3500/HDCU5500
"2-2. Top Cover".)
"2-9. DC Fan".)
"2-13. AC Inlet".)
Board".)
Clamper CN010
CN005
Locking wire saddle [B]
Harness
Flexible flat cables
Locking wire saddle [A]
Harnesses
"2-7.
2-35