2-14.
Power Switch Harness
Preparation
1.
Remove the top cover. (Refer to
2.
Remove the front panel assembly. (Refer to
Procedure
1.
Disconnect the harness from the connector (CN1006) on the PS-939 board.
2.
Remove the two screws, and then remove the SW bracket.
3.
Release the two hooks, and then pull the power switch harness from the hole of the SW bracket.
Power switch harness
SW bracket
After fitting the power switch harness in the
portion (A), tighten the screws of the SW bracket.
(b)
SW bracket
Hook
Power switch harness
Hook
Note
• Carefully attach the switch part to the hole of the SW bracket in the correct top and bottom orientation of the
switch part as shown in the figure.
• After fitting the excess portion of the power switch harness in the portion (A), tighten the screws of the SW
bracket.
• When attaching the SW bracket, tighten the screws in the following sequence: (a), (b).
4.
Install the removed parts by reversing the steps of removal.
HDCU3500/HDCU5500
"2-2. Top
Cover".)
"2-3-1. Front Panel
Harness
PSW
3 x 8
(a)
Assembly".)
Power assembly
CN1006
PS-939 board
(A)
2-34