Sony HDCU3500 Service Manual page 61

5. Remove the power assembly.
(1) Remove the two flat clamps.
(2) Disconnect the harness from the connector (CN5003) on the RE-345 board.
(3) Disconnect the harness from the connector (CN1006) on the PS-939 board.
(4) Remove the two screws, and then remove the power assembly.
PSW
3 x 8
CN5003
(RE-345 board)
Harness
Harness
Note
When attaching the power assembly, tighten the screws in the following sequence: (a), (b).
6. Install the removed parts by reversing the steps of removal.
HDCU3500/HDCU5500
Flat clamps
(b)
CN1006
(PS-939
board)
(a)
Power assembly
Front side
2-27