Rear Panel - Sony HDCU-950 Operation Manual

Rear Panel

SD output block (DIF board)
(page 11(E))
7 Expansion slot
1 HD SDI OUT 1 and HD SDI OUT 2 (HD serial
digital interface output 1 and 2) connectors (BNC
type)
The signal from the video camera may be output as
HD-SDI signals.
2 REFERENCE connectors (BNC type)
Input an HD tri-level reference sync signal or SD
reference sync signal (black burst signal) to either of
the two connectors.
The input signal is output from the other connector as-
is (loop-through output). If loop-through output is not
used, terminate the unused connector with 75 ohms.
The type of reference signal is selected using the
switch on the internal AT board, or using the MSU-
700A/750 Master Setup Unit.
For information on the switch setting on the AT board, see
page 13(E). For more information, contact a Sony service
or sales representative.
1 HD SDI OUT 1 and HD SDI OUT 2 connectors
2 REFERENCE connectors
3 SYNC OUT connector
4 PROMPTER connectors (RET4)
REFERENCE PROMPTER
RC
SD SDI
OUT 1
SD SDI HD SDI
RET1
OUT 2 OUT 1
SYNC OUT
PIX HD SDI
RET2
OUT OUT 2
WF
MONI RET3
RCP/CNU
OUT
INCOM/TALLY/PGM MIC REMOTE
qa MIC REMOTE connector (WF REMOTE)
0 RET1, RET2, and RET3 connectors
9 MONI connector
8 INCOM/TALLY/PGM connector
Note
To use the VBS signal of the HKCU-951 SD Encoder
Unit (SC phase lock is required), use an SD reference
sync signal (black burst signal).
3 SYNC OUT (sync signal output) connector
(BNC type)
Used for output of an SD composite sync signal or HD
tri-level sync from the internal sync signal generator.
(Factory setting: SD composite sync)
For information on the signal selection, contact a Sony
service or sales representative.
5 MIC1 and MIC2 connectors
6 CAMERA connector
CAMERA
MIC1
MIC2
WF MODE
qf AC IN connector
qd WF MODE connector
qs RCP/CNU connector
9(E)