2-10.
DC Fan (60 Square)
Preparation
1.
Remove the top cover. (Refer to
Procedure
1.
Open the cable clamp, and then remove the harness.
2.
Disconnect the harness from the connector (CN2003) on the RE-345 board.
3.
Open the wire saddle, and then remove the harness.
Harness
Harness
Cable clamp
Note
• When connecting the harness, wind the harness in a ring shape one time as shown in the figure, and then lock
the wire saddle.
• Check that the harness of the DC fan (60 square) is not located outside of the duct PS.
HDCU3500/HDCU5500
"2-2. Top
Cover".)
RE-345 board
Wire saddle
CN3002
Harness
Wire saddle
Duct PS
Wind the harness in a ring shape
one time, pass the harness
through the wire saddle, and lock it.
RE-345 board
CN2003
Harness
2-21