Tajimi Connector Assembly - Sony HDCU3500 Service Manual

2-4-2.

TAJIMI Connector Assembly

Preparation
1. Remove the top cover. (Refer to
2. Remove the optical cable. (Refer to step 1 in
Procedure
1. Remove the TAJIMI connector assembly.
(1) Disconnect the harness from the connector (CN3002) on the RE-345 board.
(2) Remove the four screws, and then remove the TAJIMI connector assembly.
Tip
Align the notch of the ring with the screw position and remove the screws.
(3) Remove the four screws, and then remove the lug terminal and TAJIMI CN bracket.
TAJIMI connector assembly
Ring
Screws
Rotate the ring, align the notch
with the threaded portion, and
remove the four screws.
TAJIMI connector
assembly
PSW
3 x 8
Note
• When attaching the LEMO connector assembly, install it with the red mark up.
• When attaching the TAJIMI connector assembly, secure the connector assembly temporarily using the four
screws, then fully tighten them.
2. Install the removed parts by reversing the steps of removal.
HDCU3500/HDCU5500
"2-2. Top Cover".)
"2-4-1. LEMO Connector
Rear panel assembly
PSW
3 x 8
PSW
3 x 8
Ring
Red mark
Assembly".)
Harness
TAJIMI CN bracket
Lug terminal
RE-345 board
Front side
CN3002
2-11