Hkcu-Rec55; Enc Assembly - Sony HDCU3500 Service Manual

2-19.

HKCU-REC55

2-19-1.

ENC Assembly

Preparation
1. Remove the top cover. (Refer to
2. Remove the optical cable. (Refer to step 1 in
Procedure
1. Remove the cover sheet (fiber) and current plate (MDC).
(1) Open the clamper, then remove the LC optical fiber cable.
(2) Remove the harness from the two cable clamps.
(3) Disconnect the harness from the connector (CN402) on the SY-467 board.
(4) Disconnect the LC optical fiber cable from the optical module (SFP+) on the ENC-185 board.
(5) Remove the screw, then remove the cover sheet (fiber).
(6) Remove the screw, then remove the current plate (MDC).
Supplied screw
(PSW3 x 8)
Current plate
(MDC)
Front side
Optical module (SFP+)
Current plate Current plate
(MDC) (MDC)
Boss
Correct Wrong
Note
Insert the portion A of the cover sheet (fiber) into the inside of the chassis.
HDCU3500/HDCU5500
"2-2. Top Cover")
"2-4-1. LEMO Connector
Supplied screw
(PSW3 x 8)
Cover sheet
(fiber)
Portion A
Boss
LC optical fiber cable
Assembly")
Routing of LC optical fiber cable
LC optical fiber cable
Notch
Cover sheet (fiber)
Clamper
2-51