Item
Setting Value
CAM POWER RE-
-
MOTE
ENC-M
-
ENC-S
-
Tip
• "NET" is displayed only when the HKCU-SFP50 is installed.
• "ENC-M" and "ENC-S" are displayed only when the HKCU-REC55 is installed.
MODE
Screen display
<MODE>
AUX3
: PREVIEW
MIC REMOTE
: MIC1&2
INTERCOM SOURCE
: D-SUB&IP
PGM SOURCE
: D-SUB&IP
MEDIA CLOCK DIRECT
AUDIO
: 0.000ms
HD TRUNK AUDIO
: 0.000ms
INTERCOM
: 0.000ms
TEST OUT
: IP RETURN
Description
Item
AUX3
MIC REMOTE
INTERCOM SOURCE
HDCU3500/HDCU5500
Description
Controls the power supply status to the camera.
NORMAL: When the power to the CCU is turned on, the power supply of the
camera is forcibly turned on.
BACKUP: When the CCU power is OFF, hold the command status from the
panel.
Display the ENC-185 board power supply status. (main system)
Display the ENC-185 board power supply status. (sub system)
?S07 TOP
Setting Value
Description
PREVIEW,
Set the AUX 3 pin function of the INTERCOM/TALLY/PGM
FLAG, Y TALLY
terminal.
PREVIEW: Used as PREVIEW switching signal output pin.
FLAG: Used as FLAG signal output pin.
Y TALLY: Used as Y TALLY signal output pin.
MIC1&2,
MIC1&2
MIC1,2,
•
MIC 1 and 2 Amplifier gains are common
MIC+NETWORK
MIC1,2
•
MIC 1 and 2 amplifier gains are independent
MIC+NETWORK:
•
MIC 1 and 2 Amplifier gains are common
•
14 pin is forced LEGACY
D-SUB&IP, D-
Set the signal input source used as an intercom.
SUB, IP
D-SUB&IP: Both D-SUB connector input and IP stream input
are used.
D-SUB: Only D-SUB connector input is used.
IP: Only IP stream input is used.
D-SUB&IP and IP are selectable only when the NET board is
mounted and IP Intercom stream is received. When the NET
board is not mounted, D-SUB is fixed.
Continued
4-7