Replacing The Triax Connector Assembly - Sony HXCU-100 Service Manual

5-4. Replacing the TRIAX con-
nector assembly
1. Remove the front assembly.
(Refer to Section 5-1.)
2. Remove the top cover.
(Refer to Section 5-2.)
3. Disconnect the harness from the connector
CN9 on the CN-3081 board, and release the
harness from the harness clamp.
(Refer to Section 5-2.)
4. Remove the three screws to detach the FL
cover.
5. Disconnect the harness from the connector
CN1 on the FL-349 board.
6. Remove the four screws to remove the
TRIAX connector assembly.
7. Install a new TRIAX connector assembly
by reversing the steps above.
m
. When installing the new TRIAX connec-
tor assembly, be careful of the orientation
of the capacitor.
. Attach two claws to the FL cover as
shown in the fi gure.
HXCU-100
OK NG
PSW3 x 6
CN1
FL-349 board
TRIAX connector assembly
FL cover
Capacitor
PSW3 x 6
PSW3 x 6
5-3 (E)