Omron V530-R2000 User Manual page 82

Normal Communications
While the Read Screen is displayed, communications will be performed through the
serial interface with a computer or PLC using the normal communications format.
Set the System Set./Com Mode to Normal.
p.40
n Command List
§ Designating Controller Operation
The following commands designate Controller operation, such as executing reading
and switching read conditions.
Command
@GL Performs one reading.
@SC Stops continuous reading.
@RD Outputs read data to the serial interface (polling).
@GT Executes teaching.
@GM Switches the trigger mode.
@GR Switches the read mode.
@SN Gets or switches read conditions.
@PC Switches the Camera.
Switches the screen display status between a still image and a live
@DC
image.
@WF Starts/stops the Watcher function.
Switches the display on the Watcher Screen between the 2D Code
@WD
Checker and the Condition Watcher.
@WR Clears Watcher data.
@TS Sets the date and time.
§ Backing Up and Uploading Data
The following commands back up or upload settings to/from a Memory Card or the
host.
Command
@MB Backs up settings in Memory Cards.
@MU Uploads settings from Memory Cards.
@CB Backs up settings in the host.
@CU Uploads settings from the host.
@SV Saves settings to flash memory.
Function
Function
SECTION 7
Host Communications
Page
p.67
p.67
p.68
p.68
p.69
p.69
p.70
p.70
p.71
p.71
p.71
p.72
p.74
Page
p.72
p.73
p.73
p.74
p.74
V530-R2000
User's Manual
65