Omron V530-R2000 User Manual page 12

Component Installation and Handling
n OMRON Components
Be sure to use the Camera, Camera Cable, and Console designed for the V530-
R2000.
p.6
n Cameras and Cables
Always turn OFF the power supply before connecting or disconnecting Cameras or
Cables.
n Cameras
The Camera's case is connected to the 0 V line in the internal circuits. Observe the fol-
lowing precautions to prevent noise interference.
• Do not ground the Camera.
• Do not remove the base attached to the Camera.
• Do not remove the core attached to the F150-VS-2D Camera Cable.
n Video Monitor
When using the recommended F150-M09-2D Monitor, observe the following precau-
tions to prevent noise interference. The Video Monitor case is connected to the 0 V line
in the internal circuits.
• Do not ground the Video Monitor.
• Do not ground the metallic part of the connector.
• Secure the Video Monitor with plastic screws if it is being mounted to a metallic sur-
face.
n Touching Signal Lines
To prevent damage from static electricity, use a wrist strap or another device for pre-
venting electrostatic discharges when touching terminals or signal lines in connectors.
n Memory Cards
Do NOT remove the Memory Card when the Memory Card indicator is lit.
The Memory Card or the Controller may be damaged.
p.53
PREFIX
V530-R2000
xi
User's Manual